D-Link xStack DGS-3120 Series - Chapter 47 Ipv6 Neighbor Discover Command List

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
507
Chapter 47 IPv6 Neighbor Discover
Command List
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
delete ipv6 neighbor_cache ipif [<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
show ipv6 neighbor_cache ipif [<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic |
all]
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
show ipv6 nd {ipif <ipif_name 12>}
config ipv6 nd ra ipif <ipif_name 12> {state [enable | disable] | life_time <sec 0-9000> |
reachable_time <millisecond 0-3600000> | retrans_time <millisecond 0-4294967295> |
hop_limit <value 0-255> | managed_flag [enable | disable] | other_config_flag [enable |
disable] | min_rtr_adv_interval <sec 3-1350> | max_rtr_adv_interval <sec 4-1800>}(1) (RI
Mode Only)
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr> {preferred_life_time <sec
0-4294967295> | valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]}(1) (RI Mode Only)
47-1 create ipv6 neighbor_cache
Description
This command is used to add a static neighbor on an IPv6 interface.
Format
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
Parameters
ipif - Specify the interface’s name.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<ipv6addr> - The address of the neighbor.
<macaddr> - The MAC address of the neighbor.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
Create a static neighbor cache entry: