D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1052
Chapter 113 Traffic Segmentation
Command List
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
show traffic_segmentation {<portlist>}
113-1 config traffic_segmentation
Description
This command is used to configure the traffic segmentation.
Format
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
Parameters
<portlist> - Specify a range of ports to be configured.
all - Specify that all the ports will be used for this configuration.
forward_list - Specify a range of port forwarding domain.
null - Specify a range of port forwarding domain is null.
all – Specify all ports to be configured.
<portlist> - Specify a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure traffic segmentation:
DGS-3120-24TC:admin# config traffic_segmentation 1:1-1:10 forward_list 1:11-
1:15
Command: config traffic_segmentation 1:1-1:10 forward_list 1:11-1:15
Success.
DGS-3120-24TC:admin#
113-2 show traffic_segmentation
Description
This command is used to display current traffic segmentation table.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)