D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
866
Chapter 88 RIPng Command List (RI
Mode Only)
enable ripng
disable ripng
config ripng {method [no_horizon | split_horizon | poison_reverse ] | update <sec 5-65535> |
expire <sec 1-65535> | garbage_collection <sec 1-65535>}(1)
config ripng ipif [<ipif_name 12> | all] {state [enable | disable] | metric <value 1-15>}(1)
show ripng {ipif <ipif_name 12>}
create ipv6route redistribute dst ripng src [local | static | ospfv3] {metric <value 0-16>}
config ipv6route redistribute dst ripng src [local | static | ospfv3] {metric <value 0-16>}
delete ipv6route redistribute dst ripng src [local | static | ospfv3]
88-1 enable ripng
Description
This command is used to enable RIPng globally.
Format
enable ripng
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable RIPng globally:
DGS-3120-24TC:admin#enable ripng
Command: enable ripng
Success.
DGS-3120-24TC:admin#
88-2 disable ripng
Description
This command is used to disable RIPng globally.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)