D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
166
Format
enable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specify that all the IP interfaces will be enabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable an IP interface:
DGS-3120-24TC:admin#enable ipif newone
Command: enable ipif newone
Success.
DGS-3120-24TC:admin#
12-17 disable ipif
Description
This command is used to disable an IP interface.
Format
disable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specify that all the IP interfaces will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable an IP interface:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)