D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1076
Chapter 118 VLAN Trunking Command
List
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist> | all] | state [enable | disable]
show vlan_trunk
118-1 enable vlan_trunk
Description
This command is used to enable the VLAN trunk function. When the VLAN trunk function is
enabled, the VLAN trunk ports shall be able to forward all tagged frames with any VID.
Format
enable vlan_trunk
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the VLAN Trunk:
DGS-3120-24TC:admin# enable vlan_trunk
Command: enable vlan_trunk
Success.
DGS-3120-24TC:admin#
118-2 disable vlan_trunk
Description
This command is used to disable the VLAN trunk function.
Format
disable vlan_trunk

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)