D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
151
Chapter 11 Auto-Configuration
Command List
enable autoconfig
disable autoconfig
show autoconfig
11-1 enable autoconfig
Description
This command is used to enable auto configuration. When enabled, during power on initialization,
the Switch will get configure file path name and TFTP server IP address from the DHCP server.
Then, the Switch will download the configuration file from the TFTP server for configuration of the
system.
Format
enable autoconfig
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable autoconfig:
DGS-3120-24TC:admin# enable autoconfig
Command: enable autoconfig
Success.
DGS-3120-24TC:admin#
11-2 disable autoconfig
Description
This command is used to disable auto configuration. When disabled, the Switch will configure itself
using the local configuration file

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)