D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
221
Example
To delete the CFM link trace reply:
DGS-3120-24TC:admin# delete cfm linktrace mepname mep1
Command: delete cfm linktrace mepname mep1
Success.
DGS-3120-24TC:admin#
19-21 show cfm mipccm
Description
This command is used to show the MIP CCM database entries. All entries in the MIP CCM
database will be shown. A MIP CCM entry is similar to a FDB which keeps the forwarding port
information of a MAC entry.
Format
show cfm mipccm
Parameters
None.
Restrictions
None.
Example
To show MIP CCM database entries:
DGS-3120-24TC:admin# show cfm mipccm
Command: show cfm mipccm
MA VID MAC Address Port
---------- ---- ----------------- -----
opma 1 xx-xx-xx-xx-xx-xx 2
opma 1 xx-xx-xx-xx-xx-xx 3
Total: 2
DGS-3120-24TC:admin#
19-22 config cfm mp_ltr_all
Description
This command is used to enable or disable the "all MPs reply LTRs" function.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)