D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
198
Chapter 18 Configuration Trap
Command List
config configuration trap {save [enable | disable] | upload [enable | disable] | download [enable |
disable]}
18-1 config configuration trap
Description
This command is used to configure the trap status of configuration saving completed, configuration
uploading completed and configuration downloading completed.When set to enabled, the SNMP
Agent will send a trap while the related operation (save / upload / download the configuration) is
successfully completed.
Format
config configuration trap {save [enable | disable] | upload [enable | disable] | download
[enable | disable]}
Parameters
save - (Optional) Enable or disable sending the trap by the SNMP agent when the configuration
is saved in NVRAM.
enable - Send the trap by the SNMP agent when the configuration is saved in NVRAM.
disable - No trap will be send.
upload - (Optional) Enable or disable sending the trap by the SNMP agent when successfully
uploading configuration.
enable - Send the trap by the SNMP agent when successfully uploading configuration.
disable - No trap will be send.
download - (Optional) Enable or disable sending the trap by the SNMP agent when successfully
downloading configuration.
enable - Send the trap by the SNMP agent when successfully downloading configuration.
disable - No trap will be send.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the trap of a configuration saving completed:
DGS-3120-24TC:admin#config configuration trap save enable
Command: config configuration trap save enable
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)