D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
726
IPv4 address among the IP interfaces to be the router ID. The default value of OSPFv3 router
ID is 0.0.0.0 (auto-selected). Only with executing this command, the OSPFv3 router ID can be
changed.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure OSPFv3 router ID:
DGS-3120-24TC:admin#config ospfv3 router_id 1.1.1.1
Command: config ospfv3 router_id 1.1.1.1
Success.
DGS-3120-24TC:admin#
71-2 enable ospfv3
Description
This command is used to enable OSPFv3 on the Switch.
Format
enable ospfv3
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable OSPFv3:
DGS-3120-24TC:admin#enable ospfv3
Command: enable ospfv3
Success.
DGS-3120-24TC:admin#
71-3 disable ospfv3
Description
This command is used to disable OSPFv3 on the Switch.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)