D-Link xStack DGS-3120 Series - Change Drive

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
410
GS-3120-24TC:admin#show storage_media_info
Command: show storage_media_info
Unit Drive Media Type Size Label FS Type Version
---- ----- ---------- -------- ----------- ------- -------
1 c: Flash 28 MB FFS Ver2.1
DGS-3120-24TC:admin#
38-2 change drive
Description
This command is used to change the current drive.
Format
change drive {unit <unit_id>} <drive_id>
Parameters
unit - (Optional) Specify a unit ID if in the stacking system. If not specified, it refers to the master
unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<drive_id> - Specify the drive ID. The format of drive_id is C:, D: and so on.
Restrictions
None.
Example
To display the storage media’s information:
DGS-3120-24TC:admin# change drive unit 3 c:
Command: change drive unit 3 c:
Success.
DGS-3120-24TC:admin#
38-3 md
Description
This command is used to create a directory.
Format
md {{unit <unit_id>} <drive_id>} <pathname>