D-Link xStack DGS-3120 Series - Page 416

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
411
Parameters
unit – (Optional) Specify a unit ID if in the stacking system. If not specified, it refers to the master
unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<drive_id> - (Optional) Enter the drive ID used here. Examples are C: or D:
<pathname> - Specify the directory to be removed. The path name can be specified either as a
full path name or partial name. For partial path name, it indicates the file is in the current
directory. The drive ID also included in this parameter, for example: d:/config/bootup.cfg.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To make a directory:
DGS-3120-24TC:admin# md c:/abc
Command: md c:/abc
Success.
DGS-3120-24TC:admin#
38-4 rd
Description
This command is used to remove a directory. If there are files still existing in the directory, this
command will fail and return error message.
Format
rd {{unit <unit_id>} <drive_id>} <pathname>
Parameters
unit - (Optional) Specify a unit ID if in the stacking system. If not specified, it refers to the master
unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<drive_id> - (Optional) Enter the drive ID used here. Examples are C: or D:
<pathname> - Specify the directory to be removed. The path name can be specified either as a
full path name or partial name. For partial path name, it indicates the file is in the current
directory.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To remove a directory: