D-Link xStack DGS-3120 Series - Clear Arptable

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
144
DGS-3120-24TC:admin# config arpentry 10.48.74.121 00-50-BA-00-07-37
Command: config arpentry 10.48.74.121 00-50-BA-00-07-37
Success.
DGS-3120-24TC:admin#
8-4 config arp_aging time
Description
This command is used to set the maximum amount of time, in minutes, that a dynamic ARP entry
can remain in the Switch’s ARP table, without being accessed, before it is dropped from the table.
Format
config arp_aging time <min 0-65535>
Parameters
<min 0-65535>- Enter the ARP age-out time, in minutes. This value must be between 0 and
65535 minutes.The default value is 20.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure ARP aging time to 30 minutes:
DGS-3120-24TC:admin# config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3120-24TC:admin#
8-5 clear arptable
Description
This command is used to clear all the dynamic entries from ARP table.
Format
clear arptable
Parameters
None.