xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
196
Example
To configure the Switch’s configuration file as boot up:
DGS-3120-24TC:admin#config configuration config.cfg boot_up
Command: config configuration config.cfg boot_up
Success.
17-3 save
Description
This command is used to save the current configuration to a file. This command is required to be
supported regardless of whether file system is supported or whether multiple configuration files are
supported. The configuration will only save to the master unit. For projects that support multiple
configurations, the configuration ID or configuration file name can be specified. If the configuration
ID or configuration file name is not specified, the next boot up configuration is implied.
Format
save {[config <pathname> | log | all]}
Parameters
config - (Optional) Specify to save the configuration to a file.
<pathname> - The pathname specifies the absolute pathname on the device file system. If
pathname is not specified, it refers to the boot up configuration file.
log - (Optional) Specify to save the log.
all - (Optional) Specify to save the configuration and the log.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To save the configuration:
DGS-3120-24TC:admin#save config c:/3120.cfg
Command: save config c:/3120.cfg
Saving all configurations to NV-RAM.......... Done.
17-4 show boot file
Description
This command is used to display the configuration file and firmware image assigned as boot up
files.
To Next Page
Loading...
Need help?
General