D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
427
state - Specify the IGMP state on a router interface.
enable - Specify that the IGMP state will be enabled.
disable - Specify that the IGMP state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable IGMP version 1 for the IP interface “System”:
DGS-3120-24TC:admin#config igmp ipif System version 1 state enable
Command: config igmp ipif System version 1 state enable
Success.
DGS-3120-24TC:admin#
To configure IGMPv2 for all IP interfaces:
DGS-3120-24TC:admin#config igmp all version 2
Command: config igmp all version 2
Success.
DGS-3120-24TC:admin#
40-2 show igmp
Description
This command is used to display the IGMP configuration.
Format
show igmp {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the IP interface name to be displayed.
<ipif_name 12> - Enter the IP interface name, to be displayed, here. This name can be up to
12 characters long.
If no parameter is specified, the system will display all IGMP configurations.
Restrictions
None.
Example
To display the IGMP configuration for all interfaces:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)