D-Link xStack DGS-3120 Series - Show Authen Parameter

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
82
Format
config authen parameter attempt <int 1-255>
Parameters
<int 1-255> - The amount of attempts for user's trying to login or promote the privilege on console
or telnet or SSH. This value must be between 1 and 255. Default value is 3.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the maximum attempts for user's trying to login or promote the privilege to be 9:
DGS-3120-24TC:admin# config authen parameter attempt 9
Command: config authen parameter attempt 9
Success.
DGS-3120-24TC:admin#
5-28 show authen parameter
Description
This command is used to display the parameters of authentication.
Format
show authen parameter
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the parameters of authentication: