D-Link xStack DGS-3120 Series - Show Log

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1016
DGS-3120-24TC:admin# clear log
Command: clear log
Success.
DGS-3120-24TC:admin#
106-2 show log
Description
This command is used to display the Switch’s history log.
Format
show log {[index <value_list> | severity {module <module_list>} {emergency | alert | critical |
error | warning | notice | informational | debug | <level_list 0-7>} | module<module_list>]}
Parameters
index - (Optional) The show log command will display the history log between the log number of
X and Y. For example, showing log index 1-5 will display the history log from 1 to 5.
<value_list> - Enter the index value here.
severity - (Optional) Specify the severity level used.
module - (Optional) Specify the modules which are to be displayed. The module can be obtained
by using the show log_support_module command. Use a comma to separate multiple
modules.
<module_list> - Enter the module list value here.
emergency - (Optional) Severity level 0
alert - (Optional) Severity level 1
critical - (Optional) Severity level 2
error - (Optional) Severity level 3
warning - (Optional) Severity level 4
notice - (Optional) Severity level 5
informational - (Optional) Severity level 6
debug - (Optional) Severity level 7
<level_list 0-7> - Specify a list of severity level which is to be displayed. If there is more than
one severity level, please separate them by comma. The level number is from 0 to 7.
module - (Optional) Specify the modules which are to be displayed. The module can be obtained
by using the show log_support_module command. Use a comma to separate multiple
modules.
<module_list> - Enter the module list value here.
If no parameter is specified, all history log entries will be displayed.
Restrictions
None.
Example
To display the Switch’s history log: