D-Link xStack DGS-3120 Series - Show Rspan

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
859
tx - (Optional) Only monitor egress packets.
both - (Optional) Monitor both ingress and egress packets.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure an RSPAN source entry without source target port:
DGS-3120-24TC:admin#config rspan vlan vlan_name v2 source add ports 1:2-1:5 rx
Command: config rspan vlan vlan_name v2 source add ports 1:2-1:5 rx
Success.
DGS-3120-24TC:admin#
To configure an RSPAN source entry for per flow RSPAN, without any source ports:
DGS-3120-24TC:admin#config rspan vlan vlan_id 2 source
Command: config rspan vlan vlan_id 2 source
Success.
DGS-3120-24TC:admin#
To add redirect ports for special RSPAN VLAN on intermediate or destination switch:
DGS-3120-24TC:admin#config rspan vlan vlan_name vlan2 redirect add ports 1:18-
1:19
Command: config rspan vlan vlan_name vlan2 redirect add ports 1:18-1:19
Success.
DGS-3120-24TC:admin#config rspan vlan vlan_id 2 redirect add ports 1:18-1:19
Command: config rspan vlan vlan_id 2 redirect add ports 1:18-1:19
Success.
DGS-3120-24TC:admin#
86-6 show rspan
Description
This command is used to display the RSPAN configuration.
Format
show rspan {[vlan_name <vlan_name> | vlan_id <vlanid 1-4094>]}