D-Link xStack DGS-3120 Series - Config Ssh Authmode

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
904
DGS-3120-24TC:admin# show ssh algorithm
Command: show ssh algorithm
Encryption Algorithm
--------------------------
3DES : Enabled
AES128 : Enabled
AES192 : Enabled
AES256 : Enabled
Arcfour : Enabled
Blowfish : Enabled
Cast128 : Enabled
Twofish128 : Enabled
Twofish192 : Enabled
Twofish256 : Enabled
Data Integrity Algorithm
--------------------------
MD5 : Enabled
SHA1 : Enabled
Public Key Algorithm
--------------------------
RSA : Enabled
DSA : Enabled
DGS-3120-24TC:admin#
94-3 config ssh authmode
Description
This command is used to configure user authentication method for SSH.
Format
config ssh authmode [password | publickey | hostbased] [enable | disable]
Parameters
password - Specify user authentication method.
publickey - Specify user authentication method.
hostbased - Specify user authentication method.
enable - Enable user authentication method.
disable - Disable user authentication method.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.