D-Link xStack DGS-3120 Series - Show Iproute

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
874
<tunnel_name 12> - Enter the IP tunnel interface name.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP default route:
DGS-3120-24TC:admin# delete iproute default 10.1.1.254
Command: delete iproute default 10.1.1.254
Success.
DGS-3120-24TC:admin#
89-3 show iproute
Description
This command is used to display the Switch’s current IP routing table.
Format
show iproute {[<network_address> | <ipaddr>]} {[static | rip | ospf | hardware]}
Parameters
<network_address> - (Optional) Specify the destination network address of the route to be
displayed. (RI and EI Mode Only)
<ipaddr> - (Optional) Specify the destination IP address of the route to be displayed. The longest
prefix matched route will be displayed. (RI and EI Mode Only)
static - (Optional) Specify to display only static routes. One static route may be active or inactive.
rip - (Optional) Specify to display only RIP routes. One RIP route may be active or inactive. (RI
Mode Only)
ospf - (Optional) Specify to display only OSPF routes. One OSPF route may be active or
inactive. (RI Mode Only)
hardware - (Optional) Specify to display only the routes that have been written into the chip.
Restrictions
None.
Example
To display the contents of the IP routing table: