D-Link xStack DGS-3120 Series - Show Snmp Host

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
976
DGS-3120-24TC:admin#show snmp
Command: show snmp
System Name :
System Location :
System Contact :
SNMP Trap : Enabled
SNMP State : Enabled
DGS-3120-24TC:admin#
101-19 show snmp host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp host {<ipaddr>}
Parameters
host - (Optional) The IP address of the recipient for which the traps are targeted.
<ipaddr> - Enter the IP address used for the configuration here.
If no parameter specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To show SNMP host:
DGS-3120-24TC:admin# show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------- ---------------------------------
10.90.90.3 V3 noauthnopriv initial
10.90.90.2 V2c private
10.90.90.1 V1 public
10.90.90.4 V3 authnopriv user123
10.90.90.5 V3 authpriv user234
Total Entries : 5
DGS-3120-24TC:admin#