D-Link xStack DGS-3120 Series - Show Dscp Map

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
850
Parameters
<portlist> - Enter the list of port used for this configuration here.
all - Specify that all the ports will be included in this configuration.
dscp_priority - Specify a list of DSCP value to be mapped to a specific priority.
<dscp_list> - Enter the DSCP priority list here.
to - Specify that the above or following parameter will be mapped to the previously mentioned
parameter.
<priority 0-7> - Specify the result priority of mapping.
dscp_dscp - Specify a list of DSCP value to be mapped to a specific DSCP.
<dscp_list> - Enter the DSCP to DSCP list here.
to - Specify that the above or following parameter will be mapped to the previously mentioned
parameter.
<dscp 0-63> - Specify the result DSCP of mapping.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the mapping of the DSCP priority to priority 1:
DGS-3120-24TC:admin#config dscp map 1:1-1:8 dscp_priority 1 to 1
Command: config dscp map 1:1-1:8 dscp_priority 1 to 1
Success.
DGS-3120-24TC:admin#
To configure the global mapping of the DSCP priority to priority 1:
DGS-3120-24TC:admin#config dscp map dscp_priority 1 to 1
Command: config dscp map dscp_priority 1 to 1
Success.
DGS-3120-24TC:admin#
84-19 show dscp map
Description
This command is used to show DSCP trusted port list and mapped color, priority and DSCP.
Format
show dscp map {<portlist>} [dscp_priority | dscp_dscp] {dscp <dscp_list>}
Parameters
<portlist> - (Optional) A range of ports to show. If no parameter is specified, all ports’ dscp
mapping will be displayed.
dscp_priotity - Specify a list of DSCP value to be mapped to a specific priority.