D-Link xStack DGS-3120 Series - Create Wac User; Delete Wac User

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1098
120-9 create wac user
Description
This command is used to create account for web-base access control.
This user account is independent with login user account.
If VLAN is not specified, the user will not get a VLAN assigned after the authentication.
Format
create wac user <username 15> {[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
Parameters
user - User account for web-base access control.
<username 15> - Enter the user name here. This name can be up to 15 characters long.
vlan - (Optional) Specify the target VLAN name for authenticated hosts which will uses this user
account to pass authentication.
<vlan_name 32> - Enter the name of the VLAN here. This name can be up to 32 characters
long.
vlanid - (Optional) Specify the target VLAN ID for authenticated hosts which will uses this user
account to pass authentication.
<vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a WAC local user:
DGS-3120-24TC:admin#create wac user Jim
Command: create wac user Jim
Enter a case-sensitive new password:***
Enter the new password again for confirmation:***
Success.
DGS-3120-24TC:admin#
120-10 delete wac user
Description
This command is used to delete WAC users from the local DB.
Format
delete wac [user <username 15> | all_users]