D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1103
Example
To show WAC port state and other parameters:
DGS-3120-24TC:admin# show wac ports 1-3
Command: show wac ports 1-3
Port State Aging Time Idle Time Block Time
(min) (min) (sec)
------- ------------- ------------- ------------ ------------
1:1 Enabled 60 30 120
1:2 Enabled 60 30 120
1:3 Enabled 120 60 120
DGS-3120-24TC:admin#
120-16 show wac user
Description
This command is used to show web authentication account.
Format
show wac user
Parameters
None.
Restrictions
None.
Example
To show WAC local user:
DGS-3120-24TC:admin# show wac user
Command: show wac user
User Name Password VID
----------------- ----------------- ---------
Jim pasx 1000
Total Entries: 1
DGS-3120-24TC:admin#
120-17 show wac auth_state
Description
This command is used to display the authentication state of a port.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)