D-Link xStack DGS-3120 Series - Show Syslog; Create Syslog Host

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1019
106-6 show syslog
Description
This command is used to display the syslog protocol global state.
Format
show syslog
Parameters
None.
Restrictions
None.
Example
To display the syslog protocol global state:
DGS-3120-24TC:admin# show syslog
Command: show syslog
Syslog Global State: Enabled
DGS-3120-24TC:admin#
106-7 create syslog host
Description
This command is used to create a new syslog host. The user can choose and report specific levels
of messages to a specific host. When the user chooses a specific level for a specific host,
messages which are at that severity level or higher will be reported to that host.
Format
create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency |
alert | critical | error | warning | notice | informational | debug | <level 0-7>] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state
[enable | disable]}
Parameters
<index> - Enter the host index value here.
all - Specify that all the host indexes will be used.
ipaddress - Specify the IP or IPv6 address for the host.
<ipaddr> - Specify the IP address for the host.
<ipv6addr> - Specify the IPv6 address for the host.
severity - (Optional) Specify the severity level.