D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
893
Example
To create a backup schedule on time range "range_1":
DGS-3120-24TC:admin#create backup config time_range range_1 filename c:/bk-
confi
g-1
Command: create backup config time_range range_1 filename c:/bk-config-1
Success.
DGS-3120-24TC:admin#
92-2 config backup
Description
This command is used to enable or disable a schedule backup.
Format
config backup [config | log] time_range <range_name 32> filename <pathname> state
[enable | disable]
Parameters
config - Schedule to back up configuration.
log - Schedule to back up log.
time_range - The schedule to back up the configuration or log.
<range_name32> - Enter the name of the time range. Maximum 32 characters.
filename - The backup filename of the configuration or log.
<pathname> - Enter the backup file path name.
state - (Optional) Enable or disable the backup schedule when the schedule is created.
enable – Enable the backup schedule.
disable – Disable the backup schedule.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable a backup schedule on time range "range_1":
DGS-3120-24TC:admin# config backup log time_range range_1 filename bk-dgs-log
state enable
Command: config backup log time_range range_1 filename bk-dgs-log state enable
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)