D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1071
Chapter 117 VLAN Counter Command
List (RI and EI Mode Only)
create vlan_counter [vlan <vlan_name> | vlanid <vidlist>] {ports [<portlist> | all]} [all_frame |
broadcast | multicast | unicast] [packet | byte] {[rx | tx]}
clear vlan_counter statistics [all | [vlan <vlan_name> | vlanid <vidlist>] [all | ports <portlist>]] {[rx
| tx]}
delete vlan_counter [all | [vlan <vlan_name> | vlanid <vidlist>] [all | ports <portlist> [all | [all_frame
| broadcast | multicast | unicast] [packet | byte]]]] {[rx | tx]}
show vlan_counter {[vlan <vlan_name> | vlanid <vidlist>]} {[rx | tx]}
show vlan_counter statistics {[vlan <vlan_name> | vlanid <vidlist>] {ports <portlist>}} {[rx | tx]}
117-1 create vlan_counter
Description
This command is used to create the control entry for VLAN traffic flow statistics. A control entry
can be created to count ingress and/or egress statistics for a specific VLAN or to count statistics
for a specific port on a specific VLAN on the ingress pipeline or egress pipeline. The statistics can
be counted for different frame types either by byte or by packet. Both ingress and egress statistics
are created if the direction is not specified.
Format
create vlan_counter [vlan <vlan_name> | vlanid <vidlist>] {ports [<portlist> | all]} [all_frame |
broadcast | multicast | unicast] [packet | byte] {[rx | tx]}
Parameters
vlan - Specify the VLAN name that will be used for this configuration.
<vlan_name> - Enter the VLAN name that will be used for this configuration.
vlanid - Specify the VLAN ID that will be used for this configuration.
<vidlist> - Enter the VLAN ID that will be used for this configuration.
ports - (Optional) Specify the list of ports that will be used for this configuration.
<portlist> - Enter the list of ports that will be used for this configuration.
all - Specify that all ports will be used for this configuration.
all_frame - Specify that all packets will be counted regardless of the packet type.
broadcast - Specify that only broadcast packets will be counted.
multicast - Specify that only multicast packets will be counted.
unicast - Specify that only unicast packets will be counted.
packet - Specify that the statistics is counted by packets.
byte - Specify that the statistics is counted by bytes.
rx - (Optional) Specify that the statistics is counted for ingress traffic.
tx - (Optional) Specify that the statistics is counted for egress traffic.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)