D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
851
dscp_dscp - Specify a list of DSCP value to be mapped to a specific DSCP.
dscp - (Optional) This specifies DSCP value that will be mapped.
<dscp_list> - Enter the DSCP list here.
Restrictions
None.
Example
In case of project support per port configure, show DSCP map configuration on port 1:1.
DGS-3120-24TC:admin# show dscp map 1:1 dscp_dscp
Command: show dscp map 1:1 dscp_dscp
DSCP to DSCP Mapping:
--------------------------------------------------------------
Port 1:1 | 0 1 2 3 4 5 6 7 8 9
-----------+--------------------------------------------------
0 | 0 1 2 3 4 5 6 7 8 9
1 | 10 11 12 13 14 15 16 17 18 19
2 | 20 21 22 23 24 25 26 27 28 29
3 | 30 31 32 33 34 35 36 37 38 39
4 | 40 41 42 43 44 45 46 47 48 49
5 | 50 51 52 53 54 55 56 57 58 59
6 | 60 61 62 63
--------------------------------------------------------------
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)