D-Link xStack DGS-3120 Series - Page 663

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
658
Format
config stp trap {topo_change [disable | enable ] | new_root [enable | disable]}(1)
Parameters
topo_change - Specify the state of sending new root traps. The default state is enable.
disable - Disable sending new root traps.
enable - Enable sending new root traps.
new_root - Specify the state of sending topology change traps. The default state is enable.
enable - Enable sending topology change traps.
disable - Enable sending topology change traps.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the sending state for STP traps:
DGS-3120-24TC:admin#config stp trap new_root enable
Command: config stp trap new_root enable
Success.
DGS-3120-24TC: