D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
999
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To upload configuration:
DGS-3120-24TC:admin# upload sim_ms configuration_to_tftp 10.55.47.1
D:\configuration.txt members 1
Command: upload sim_ms configuration_to_tftp 10.55.47.1 D:\configuration.txt
members 1
This device is uploading configuration. Please wait several minutes ...
Upload Status :
ID MAC Address Result
--- ----------------- ----------------
1 00-1A-2D-00-12-12 Success
DGS-3120-24TC:admin#
102-9 config sim trap
Description
This command is used to control sending of traps issued from the member switch.
Format
config sim trap [enable | disable]
Parameters
enable - Enable the trap state.
disable - Disable the trap state.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable sim trap:
DGS-3120-24TC:admin# config sim trap enable
Command: config sim trap enable
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)