D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1039
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure time:
DGS-3120-24TC:admin# config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DGS-3120-24TC:admin#
110-7 config time_zone
Description
This command is used to configure time zone of the device.
Format
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
Parameters
operator - (Optional) Specify the operator of time zone.
[+ | -] - Specify that time should be added or subtracted to or from the GMT.
hour - (Optional) Specify the hour of time zone.
<gmt_hour 0-13> - Enter the hour value of the time zone here. This value must be between 0
and 13.
min - (Optional) Specify the minute of time zone.
<minute 0-59> - Enter the minute value of the time zone here. This value must be between 0
and 59.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure time_zone:
DGS-3120-24TC:admin# config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)