D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
66
5-5 enable authen_policy
Description
This command is used to enable system access authentication policy.
Enable system access authentication policy. When authentication is enabled, the device will adopt
the login authentication method list to authenticate the user for login, and adopt the enable
authentication method list to authenticate the enable password for promoting the user‘s privilege to
Admin level.
Format
enable authen_policy
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable system access authentication policy:
DGS-3120-24TC:admin# enable authen_policy
Command: enable authen_policy
Success.
DGS-3120-24TC:admin#
5-6 disable authen_policy
Description
This command is used to disable system access authentication policy.
Disable system access authentication policy. When authentication is disabled, the device will
adopt the local user account database to authenticate the user for login, and adopt the local
enable password to authenticate the enable password for promoting the user‘s privilege to Admin
level.
Format
disable authen_policy
Parameters
None.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)