D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1024
DGS-3120-24TC:admin# config log_save_timing on_demand
Command: config log_save_timing on_demand
Success.
DGS-3120-24TC:admin#
106-12 show log_save_timing
Description
This command is used to show the method for saving the log.
Format
show log_save_timing
Parameters
None.
Restrictions
None.
Example
To show the timing method used for saving the log:
DGS-3120-24TC:admin#show log_save_timing
Command: show log_save_timing
Saving Log Method: On_demand
DGS-3120-24TC:admin#
106-13 show attack_log
Description
This command is used to display the attack log messages. The attack log message refers to log
messages driven by modules such as DOS and the IP-MAC-port binding module. This type of log
message may generate a large amount of messages and quickly cause the system to run out of
system log storage. Therefore, for this type of log messages only the first log that is generated
each minute can be stored in the system log, with the rest of them being stored in a separate table
named attack log.
Format
show attack_log {unit <unit_id 1-6} {index <value_list>}

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)