Command: show traffic control 1:1-1:10
Traffic Control Trap : [Both]
Traffic Control Log : Enabled
Traffic Control Auto Recover Time: 0 Minutes
Port Broadcast/ Multicast/ Unicast/ Action Count Time Shutdown
Threshold Threshold Threshold down Interval Forever
---- --------- --------- --------- -------- -------- --------- --------
1:1 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:2 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:3 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:4 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:5 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:6 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:7 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:8 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:9 Enabled Disabled Disabled shutdown 5 10
1 1 1
1:10 Enabled Disabled Disabled shutdown 5 10
1 1 1
112-4 config traffic control log state
Description
This command is used to configure the traffic control log state. When the log state is enabled,
traffic control states are logged when a storm occurs and when a storm is cleared. If the log state
is disabled, traffic control events are not logged.
NOTE: The log state is only applicable for shutdown mode. Since shutdown mode only support
broadcast and multicast storm control, doesn’t support unicast storm control. The log only
generate for broadcast and multicast storm control.
Format
config traffic control log state [enable | disable]
Parameters
To Next Page
Loading...
Need help?
General
