D-Link xStack DGS-3120 Series - Page 1072

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1067
Format
config vrrp ipif <ipif_name 12> [authtype [none | simple authdata <string 8> | ip authdata
<string 16>]]
Parameters
ipif - Specify the name of IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
authtype - Specify the VRRP’s authentication type.
none - Specify that no authentication algorithm will be used on this interface.
simple - Specify that the authentication algorithm will be set to simple text on this interface.
authdata - Specify the authentication data used in the simple text authentication algorithm.
<string 8> - Enter the authentication data used in the simple text authentication
algorithm here. This value can be up to 8 characters long.
ip - Specify that the authentication algorithm will be set to IP authentication header on this
interface.
authdata - Specify the authentication data used in the IP authentication header algorithm.
<string 16> - Enter the authentication data used in the IP authentication header
algorithm here. This value can be up to 16 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a VRRP IP interface:
DGS-3120-24TC:admin#config vrrp ipif System authtype simple authdata 12345678
Command: config vrrp ipif System authtype simple authdata 12345678
Success.
DGS-3120-24TC:admin#
116-6 delete vrrp
Description
This command is used to delete the VRRP entries.
Format
delete vrrp {vrid <vrid 1-255> ipif <ipif_name 12>}
Parameters
vrid - (Optional) Specify the Virtual Router ID used.
<vrid 1-255> - Enter the Virtual Router ID used here. This value must be between 1 and 255.
ipif - (Optional) Specify the IP interface name used.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12