D-Link xStack DGS-3120 Series - Page 116

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
111
default TC.
<value 0-63> - Enter the replace DSCP with value here. This value must be between 0
and 63.
replace_tos_precedence_with - (Optional) Specify that the IP precedence of the outgoing
packet is changed with the new value. If used without an action priority, the packet is sent
to the default TC.
<value 0-7> - Enter the replace ToS precedence with value here. This value must be
between 0 and 7.
counter - (Optional) Specify whether the ACL counter feature is enabled or disabled. This
parameter is optional. The default option is disabled. If the rule is not bound with the
flow_meter, all matching packets are counted. If the rule is bound with the flow_meter, then
the “counter” is overridden.
enable - Specify that the ACL counter feature will be enabled.
disable - Specify that the ACL counter feature will be disabled.
mirror - Specify that packets matching the access rules are copied to the mirror port.
group_id - (Optional) Specify the groupd ID.
<value 1-4> - Enter the value between 1 and 4.
deny - Specify that packets matching the access rule are filtered by the Switch.
time_range - (Optional) Specify the name of the time range entry.
<range_name 32> - Enter the time range name here. This name can be up to 32
characters long.
delete access_id - Specify to delete the access ID. The value range is 1-256, but the supported
maximum number of entries depends on the project.
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a rule entry for a packet content mask profile (option 3):
DGS-3120-24TC:admin# config access_profile profile_id 5 add access_id
auto_assign packet_content offset5 0xF0 port all deny
Command: config access_profile profile_id 5 add access_id auto_assign
packet_content offset5 0xF0 port all deny
Success.
DGS-3120-24TC:admin#
6-4 show access_profile
Description
This command is used to display the current access list table.
Format
show access_profile {[profile_id <value 1-6> | profile_name <name 1-32>]}
Parameters
profile_id - (Optional) Specify the index of the access list profile.