D-Link xStack DGS-3120 Series - Page 191

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
186
delimiter - (Optional)Specify whether to use delimiter and number of delimiters for MAC address.
hyphen - (Optional) Use “-” when specifying MAC address, e.g. aa-bb-cc-dd-ee-ff.
colon - (Optional) Use “:” when specifying MAC address, e.g. aa:bb:cc:dd:ee:ff.
dot - (Optional) Use “.”when specifying MAC address, e.g. aa.bb.cc.dd.ee.ff.
none - (Optional) Do not use any delimiter when specifying MAC address, e.g. aabbccddeeff.
number - (Optional)Specify the number of delimiters.
1 - Use one delimiter, e.g. aabbcc-ddeeff.
2 - Use two delimiters, e.g. aabb-ccdd-eeff.
5 - Use five delimiters, e.g. aa-bb-cc-dd-ee-ff.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MAC address format to IEFT style:
DGS-3120-24TC:admin#config authentication mac_format case uppercase delimiter
hyphen number 5
Command: config authentication mac_format case uppercase delimiter hyphen number
5
Success.
DGS-3120-24TC:admin#
16-6 show authentication guest_vlan (RI and EI Mode Only)
Description
This command is used to show guest VLAN setting.
Format
show authentication guest_vlan
Parameters
None.
Restrictions
None.
Example
This example displays the guest VLAN setting: