D-Link xStack DGS-3120 Series - Page 260

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
255
22-14 debug dhcpv6_client packet
Description
This command is used to enable or disable debug information flag for DHCPv6 client packet,
including packet receiving and sending.
Format
debug dhcpv6_client packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specify the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable DHCPv6client packet sending debug flags:
DGS-3120-24TC:admin#debug dhcpv6_client packet sending state enable
Command: debug dhcpv6_client packet sending state enable
Success.
DGS-3120-24TC:admin#
22-15 debug dhcpv6_relay state enable
Description
This command is used to enable DHCPv6 relay debug functions.
Format
debug dhcpv6_relay state enable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.