D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
279
To enable the VRRP interface state change debug flag:
DGS-3120-24TC:admin#debug vrrp interface_change state enable
Command: debug vrrp interface_change state enable
Success.
DGS-3120-24TC:admin#
To enable the VRRP timers debug flag:
DGS-3120-24TC:admin#debug vrrp timers state enable
Command: debug vrrp timers state enable
Success.
DGS-3120-24TC:admin#
22-43 debug vrrp clear counter (RI Mode Only)
Description
This command is used to reset the VRRP debug statistic counters.
Format
debug vrrp clear counter
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To clear VRRP statistic counters:
DGS-3120-24TC:admin#debug vrrp clear counter
Command: debug vrrp clear counter
Success.
DGS-3120-24TC:admin#
22-44 debug vrrp log state (RI Mode Only)
Description
This command is used to enable or disable the VRRP debug log state.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)