D-Link xStack DGS-3120 Series - Page 296

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
291
24-2 config dhcp_local_relay vlan vlanid
Description
This command is used to enable or disable DHCP local relay function for specified VLAN ID.
Format
config dhcp_local_relay vlan vlanid <vlan_id 1-4094> state [enable | disable]
Parameters
vlanid - Specify the VLAN ID that the DHCP local relay function will be enabled.
<vlan_id 1-4094> - Enter the VLAN ID used here.
state - Enable or disable DHCP local relay for specified VLAN.
enable - Specify that the DHCP local relay function will be enabled.
disable - Specify that the DHCP local relay function will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable DHCP local relay for default VLAN:
DGS-3120-24TC:admin# config dhcp_local_relay vlan vlanid 1 state enable
Command: config dhcp_local_relay vlan vlanid 1 state enable
Success.
DGS-3120-24TC:admin#
24-3 enable dhcp_local_relay
Description
This command is used to globally enable the DHCP local relay function on the Switch.
Format
enable dhcp_local_relay
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.