D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
336
26-27 show dhcp conflict_ip
Description
This command is used to display the IP address that has been identified as being in conflict.
The DHCP server will use ping packet to determine whether an IP address is conflicting with other
hosts before binding this IP. The IP address which has been identified in conflict will be moved to
the conflict IP database. The system will not attempt to bind the IP address in the conflict IP
database unless the user clears it from the conflict IP database.
Format
show dhcp conflict_ip {<ipaddr>}
Parameters
<ipaddr> - (Optional) Specify the IP address to be displayed.
Restrictions
None.
Example
To display the entries in the DHCP conflict IP database:
DGS-3120-24TC:admin#show dhcp conflict_ip
Command: show dhcp conflict_ip
IP Address Detection Method Detection Time
----------- ---------------- --------------------
172.16.1.32 Ping 2007/08/30 17:06:59
172.16.1.32 Gratuitous ARP 2007/09/10 19:38:01
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)