D-Link xStack DGS-3120 Series - Page 355

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
350
28-2 disable dhcpv6_relay
Description
This command is used to disable the DHCPv6 relay function on the Switch.
Format
disable dhcpv6_relay
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the DHCPv6 relay global state to disable:
DGS-3120-24TC:admin#disable dhcpv6_relay
Command: disable dhcpv6_relay
Success.
DGS-3120-24TC:admin#
28-3 config dhcpv6_relay
Description
The command is used to add or delete an IPv6 address which is a destination to forward (relay)
DHCPv6 packets.
Format
config dhcpv6_relay [add|delete] ipif <ipif_name 12> <ipv6addr>
Parameters
add - Add an IPv6 destination to the DHCPv6 relay table.
delete - Delete an IPv6 destination from the DHCPv6 relay table.
ipif - The IP information for DHCPv6 relay.
<ipif_name 12> - The name of the IP interface in which DHCPv6 relay is to be enabled.
<ipv6addr> - The DHCPv6 server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.