D-Link xStack DGS-3120 Series

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
369
DGS-3120-24TC:admin#show dvmrp
Command: show dvmrp
DVMRP Global State : Disabled
Interface IP Address Neighbor Timeout Probe Metric State
------------ ----------------- ---------------- ----- ------ --------
System 10.90.90.90 35 10 1 Disabled
Total Entries: 1
DGS-3120-24TC:admin#
30-5 show dvmrp neighbor
Description
This command is used to display the DVMRP neighbor table.
Format
show dvmrp neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
Parameters
ipif - (Optional) Specify the IP interface name used for the display.
<ipif_name 12> - Enter the IP interface name used for the display here. This name can be up
to 12 characters long.
ipaddress - (Optional) Specify the IP address and netmask of the destination used.
<network_address> - Enter the IP address and netmask of the destination used here.
If no parameter is specified, the system will display the whole DVMRP neighbor table.
Restrictions
None.
Example
To display DVMRP neighbor table: