D-Link xStack DGS-3120 Series - Page 412

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
407
Parameters
None.
Restrictions
None.
Example
To display the DHCP server/client filter list created on the Switch:
DGS-3120-24TC:admin# show filter netbios
Command: show filter netbios
Enabled Ports: 1-3
DGS-3120-24TC:admin#
37-3 config filter extensive_netbios
Description
This command is used to configure the Switch to filter NETBIOS packets over 802.3 flame on the
specific ports.
Format
config filter extensive_netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports used for this configuration here.
all - Specify that all the ports will be used this configuration.
state - Enable or disable the filter to block the NETBIOS packet over 802.3 frame.
enable - Specify that the filter state will be enabled.
disable - Specify that the filter state will be disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure a DHCP client/server filter entry.
DGS-3120-24TC:admin# config filter extensive_netbios 1-10 state enable
Command: config filter extensive_netbios 1-10 state enable
Success.
DGS-3120-24TC:admin#