D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
435
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the IGMP proxy:
DGS-3120-24TC:admin#disable igmp_proxy
Command: disable igmp_proxy
Success.
DGS-3120-24TC:admin#
41-3 config igmp_proxy downstream_if
Description
This command is used to configure the IGMP proxy downstream interfaces. The IGMP proxy plays
the server role on the downstream interfaces. The downstream interface must be an IGMP-
snooping enabled VLAN.
Format
config igmp_proxy downstream_if [add | delete] vlan [<vlan_name 32> | vlanid <vidlist>]
Parameters
add - Specify to add a downstream interface.
delete - Specify to delete a downstream interface .
vlan – Specify the VLAN by name or ID.
<vlan_name 32> - Specify a name of VLAN which will be added to or deleted from the IGMP
proxy downstream interface. The maximum length is 32 characters.
vlanid - Specify a list of VLAN IDs to be added to or deleted from the IGMP proxy
downstream interface.
<vidlist> - Specify a list of VLAN IDs which will be added to or deleted from the IGMP
proxy downstream interface.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IGMP proxy’s downstream interface:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)