xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
443
IGMP packet received by the VLAN has a version higher than the specified version, this
<value 1-3> - Enter the version number here. This value must be between 1 and 3.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IGMP snooping querier:
DGS-3120-24TC:admin# config igmp_snooping querier vlan_name default
query_interval 125 state enable
Command: config igmp_snooping querier vlan_name default query_interval 125
state enable
Success.
42-4 config igmp access_authentication ports
Description
This command is used to enable or disable the IGMP Access Control function for the specified
ports. If the IGMP Access Control function is enabled and the Switch receives an IGMP JOIN
message, the Switch will send the access request to the RADIUS server for authentication.
Format
config igmp a
ccess_authentication p
orts [all | <portlist>
] state [enable | disable]
Parameters
all - Specify all ports to be configured.
<portlist> - Specify a range of ports to be configured.
state - Specify the state of the RADIUS authentication function on the specified ports.
enable - Enable the RADIUS authentication function on the specified ports.
disable - Disable the RADIUS authentication function on the specified ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable IGMP Access Control for all ports:
To Next Page
Loading...
Need help?
General
