D-Link xStack DGS-3120 Series - Page 466

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
461
42-22 show igmp access_authentication ports
Description
This command is used to display the current IGMP Access Control configuration.
Format
show igmp access_authentication ports [all | <portlist>]
Parameters
all - Specify all ports to be displayed.
<portlist> - Specify a range of ports to be displayed.
Restrictions
None.
Example
To display the IGMP Access Control status for ports 1-4:
DGS-3120-24TC:admin#show igmp access_authentication ports 1:1-1:4
Command: show igmp access_authentication ports 1:1-1:4
Port State
----- ---------
1:1 Enabled
1:2 Disabled
1:3 Disabled
1:4 Disabled
DGS-3120-24TC:admin#
To display the IGMP Access Control status for all ports:
DGS-3120-24TC:admin#show igmp access_authentication ports all
Command: show igmp access_authentication ports all
Port State
----- ---------
1:1 Enabled
1:2 Disabled
1:3 Disabled
1:4 Disabled
1:5 Disabled
1:6 Disabled
1:7 Disabled
1:8 Disabled
1:9 Disabled
1:10 Disabled
1:11 Disabled