D-Link xStack DGS-3120 Series

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
505
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
None.
Example
To show an IP tunnel interface’s information (Tunnel name is “tn2”):
DGS-3120-24TC:admin#show ip_tunnel tn2
Command: show ip_tunnel tn2
Tunnel Interface : tn2
Interface Admin State : Enabled
Tunnel Mode : ISATAP
IPv6 Link-Local Address : FE80::5EFE:A00:1/128
IPv6 Global Unicast Address : 2001::5EFE:A00:1/64
Tunnel Source : 10.0.0.1
Tunnel Destination : Unknown
DGS-3120-24TC:admin#
46-8 enable ip_tunnel
Description
This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch.
Format
enable ip_tunnel {<tunnel_name 12>}
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable an IP tunnel interface (Tunnel name is “tn2”):