D-Link xStack DGS-3120 Series - Page 514

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
509
Format
show ipv6 neighbor_cache ipif [<ipif_name 12> | all] [ipv6address <ipv6addr> | static |
dynamic | all]
Parameters
ipif - Specify the IPv6 interface name
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
all - Specify that all the interface will be displayed.
ipv6address - The neighbor’s address.
<ipv6addr> - Enter the IPv6 address here.
static - Static neighbor cache entry.
dynamic - Dynamic entries.
all - All entries include static and dynamic entries.
Restrictions
None
Example
Show all neighbor cache entries of IP interface “System”:
DGS-3120-24TC:admin#show ipv6 neighbor_cache ipif System all
Command: show ipv6 neighbor_cache ipif System all
3FFC::1 State: Static
MAC Address : 00-01-02-03-04-05 Port : NA
Interface : System VID : 1
Total Entries: 1
DGS-3120-24TC:admin#
47-4 config ipv6 nd ns retrans_time
Description
This command is used to configure the IPv6 ND neighbor solicitation retransmit time, which is
between retransmissions of neighbor solicitation messages to a neighbor when resolving the
address or when probing the reachability of a neighbor.
Format
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
Parameters
ipif - The IPv6 interface name