D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
518
Using the JWAC function, PC users need to pass two stages of authentication. The first stage is to
do the authentication with the quarantine server and the second stage is the authentication with
the Switch. For the second stage, the authentication is similar to WAC, except that there is no port
VLAN membership change by JWAC after a host passes authentication. The RADIUS server will
share the server configuration defined by the 802.1X command set.
Format
enable jwac
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable JWAC:
DGS-3120-24TC:admin#enable jwac
Command: enable jwac
Success.
DGS-3120-24TC:admin#
49-2 disable jwac
Description
This command is used to disable JWAC.
Format
disable jwac
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable JWAC:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)