D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
588
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete the loopback interface named loopback1:
DGS-3120-24TC:admin#delete loopback ipif loopback1
Command: delete loopback ipif loopback1
Success.
DGS-3120-24TC:admin#
55-4 show loopback ipif
Description
This command is used to display the information of the loopback interface.
Format
show loopback ipif {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) Enter the IP interface name used for this configuration here. This
name can be up to 12 characters long.
Restrictions
None.
Example
To show the information of the loopback interface named loopback1:
DGS-3120-24TC:admin#show loopback ipif loopback1
Command: show loopback ipif loopback1
Loopback Interface : loopback1
Interface Admin State : Enabled
IPv4 Address : 20.0.0.2/8 (Manual)
Total Entries : 1
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)